IC-7000: Set Mode

[last updated: 2023-09-17]
ham radio
Icom-7000
-----

(Procedure to set RF power is half-way down the page)_

• Set Mode:
• Used for programming parameters that only need to be changed occasionally.
• Four Set modes:
  QuickSet
  Display Set
  Timer Set
  Misc/Other Set
• General Procedure:
  • Refer to the operating manual (pp 120-136) f to find the parameter you want to change
    Find which Set Mode your desired parameter belongs to: QS, DISP, TIME, or OTH
    Note the Set Mode Item Number for your desired parameter.
  • Enter Set Mode:
    push AF(set) momentarily (top left knob)
    "SET MODE" header will display
  • Press F 1-4 to select the Set Mode desired: QS, DISP, TIME, or OTH
  • Use F1 & 2 to scroll through parameter list until desired one is highlighted.
    Rotate VFO knob to scroll through parameter options and select the option value desired
  • Press AF(set) 2x to exit out of Set Mode

• Set RF Power:
• When you first power on the radio, the output power will display on the screen for about 2 seconds.
• Power settings are different and must be set independently for each band selected.
• The RF Power parameter is located in the "QuickSet group," and is item #1 in that group.
• Press AF to enter "Set Mode."
  Press F1/QS - QuickSet
  RF power is parameter #1
• Rotate Dial (big knob on right) to change power setting to what you want
• Press AF twice to exit Set Mode
  Turn power off then back on to confirm the settings are correct.

.

.

.


eof